Engine rebuild kit for 1.6 engines

All the gaskets and bearings required for an engine rebuild, right down to spark plugs and the exhaust manifold gasket. These are the same parts we use to build every motor that leaves Flyin' Miata. For example, the bearings are top-quality tri-metal. The picture may not be completely accurate, so please read the list of parts below.

Motors with a four-slot front crank pulley and a VIN of 209446 (built mid-1991) or lower are "short nose" engines and should select the appropriate base kit. Eight slots and a VIN higher than 209446 are big nose engines.

Includes:

• Belt, Timing (Camshaft)
• Headgasket, 1990-93, .040" MLS
• Cam Sensor O-Ring
• Oil Cap O-ring
• Valve Cover Gasket
• Gaskets, Thermostat, all years (one for the front, one for the rear, two total)
• O-ring, Thermostat housing
• Seal, Rear Crank Oil, all years
• Seals, Camshaft Oil
• Seals, F/R oil pan end
• Gasket, oil pick up, all years
• Gasket, intake manifold
• Seal, Front Crankshaft
• 16 Valve Stem Seals
• Gasket, oil pump (small nose engines only)
• O-ring, oil pump (big nose engines only)
• Oil Filter (Aftermarket)
• Dip Stick Tube O-ring
• PCV valve grommet
• NGK ZFR6F-11 spark plugs
• ACL Race main bearings
• ACL Race rod bearings 
• ACL Race thrust bearings
• PCV Valve, Turbo - all years
• Pulley, Tensioner
• Pulley, Idler
• Gasket, Exhaust Manifold
• Thermostat, 180 degree
  

The kit does not include piston rings, oil or water pumps, or assembly lube. You can add our recommended assembly lube to your cart (below), we leave it out in case you have a different preference. It also doesn't include sealant for shipping reasons, but you can get it locally - we recommend Permatex "Right Stuff" from NAPA, 7652694.