Ball joint boot installation tool (Moog for NA)
Ball joint boot installation tool (Moog for NA)
Collapsible content
Description
When you install the Moog ball joints in your NA upper control arm, you need to press the boot into place once the ball joint has been installed. This is a surprisingly challenging thing, but it's not very challenging to accidentally cut the boot in the process. Take the risk out of that job with this tool - place the boot into place, slip this tool over, snug down the nut (only until the boot seats), then remove the tool and put it all back together. Easy! Boots aren't sold separately, so if you damage a boot you need to buy a whole new ball joint.
Instructions
Instructions are not currently available.
Shipping
$9.99 flat rate shipping. Orders over $40 ship for free in the US!
Details
There are no shipping restrictions on this item.
What does it fit?
Emissions
Emissions do not apply.
Warranty
1 year
SKU
Neat little tool, it took not even 2 minutes to pop both boots on the ball joints. Ended up being about 20$ with shipping, I’d say it’s worth it
Works like a charm. Took all of 20 seconds to install each boot with this tool. Well Done FM.
OK this is probably the best $9.99 that I have spent while Rebuilding my Miata. It literally took Two Minutes to install both ball joint Boots. I put a thin coat of Dish Soap on the inside surface of the Boot and they popped on super easy.