2.5" brake duct inlet kit for 2001-2005
2.5" brake duct inlet kit for 2001-2005
Exclusive to Flyin' Miata!
Couldn't load pickup availability
Collapsible content
Description
Need to feed some cooling air to the brakes on your 2001-05 Miata? This is an easy solution, assuming you still have a stock front bumper. These ducts bolt in where your fog lights are now, and are a direct replacement - no trimming or funniness necessary. They even include new hardware and caps for the fog light harness (note that the caps are for H1 connectors, which are only used on 2001-03 Miatas)! This kit does not include hose or backing plates to be used at the wheel, it is the inlet only.
Fits both Mazdaspeed and non-Mazdaspeed Miatas.
This is another part from our You Design program, which gives the DIY community an outlet for their designs and an opportunity to make money from their hard work and ingenuity. Do you have a polished design you think the Miata community could benefit from? Please reach out to us at printme@flyinmiata.com!
Instructions
Instructions are not currently available.
Shipping
What does it fit?
Fits: 2001, 2002, 2003, 2004, 2004 MSM, 2005, 2005 MSM
Emissions
Emissions do not apply.
Warranty
1 year
SKU
The ducts themselves are fantastic. They slide into place with little drama and like the other review, you're best off using a washer so the screws can hold the ducts in place. I was able to make m6x12 washers work so that's my recommendation. My only gripe is that the 3d printed caps for your fog light harness are too thick. My NB2 connectors are roughly 5/8" (~15.8mm for the metric crowd) but they have these little winglets that make them about a 3/4" (~16mm) wide total. The caps are 3/4" so they're too wide for the connector. I just ended depinning my connector and wrapping the open end with a lot of electrical tape for now. Outside of that, these look amazing...now to sort out the rest of the ducting...
Also apologies for the crude photos...they were harder than expected to capture
Perfectly fit the provided screws are just a hair too small if you're going to use them add a washer, the OEM ones that you use for the fog lights work great. Perfect fit slide without issue right over the OEM location fitment is a 9/10 with a tiny gap I'm sure if you take your time you can make it perfect. 2 minute install I just turned the wheels and screwed them in after I got them painted.