Hub stand floor plate kit (set of 4)

Great in concept, but a bit too small,nwhich vauses a lot of extra work.

Works fine for the rears on an ND. However, on the front when you rotate the wheel for caster, these tend to roll off the plates as the car will start to twist (yaw).

While setting caster....best bet is to not put the rears on plates which helps keep the rear from shifting left to right. This helps keep the fronts from rolling off the plates.

Every turn of the steering wheel, I check the stands to make sure they are centered on the plates. If not, I push the car by hand back on center.

I think if the plates were about a inches bigger for the Fronts this would not be a problem.

Still glad I have these as those stands can really chew up your garage floor.

Much heavier and bigger than I thought