Performance specialists

Took less than 10 minutes. They look great

Exactly what my car need. Replacement of my 23 year old bushings.

02 NB2. I definitely was not expecting the ride quality and the cornering to be so much different than stock just by putting a set of sway bars on . I read the reviews and yes, even I was skeptical. This upgrade is definitely must have for any enthusiast . The install was a breeze 25 minutes start to finish .. I watched the install video and that made it a breeze . I would definitely recommend these bars 10 fold !

Super good quality
Amazing templates witch helped a ton with the cutting process
High quality powder coating
Used these on a 98 gmc Sonoma and surprisingly it matched the wheel arches well enough
Great product fast shipping would buy again

Easy to install. Fits perfectly. Only takes a few seconds to install. I would recommend these. Good upgrade from factory parts

Nice looking, well packaged, easy to install.

These are an excellent upgrade for NAs with stock springs. Very comfortable ride, better control of roll and squat/dive. Definitely too soft for aftermarket springs, but perfect for me.

..because they are genius! '18 Brembo Club, and never realized that door bushings would improve the ride. Not only did the 1st generation bushings make a difference in my car, these 2nd gen bushings are the answer you never thought about asking! I used a brass hammer to reduced the PS steel cup slightly, to snug up the fit (which was easier than filing and sanding the 1st gen Delrin to make them fit). Both doors now close like a soft kiss.

We have a particular road which is popular with street bikes and sports cars, that winds up into the hills, before plunging back down to the side of the bay. Nearly all the turns are sharp, poorly angled, and have a severe crown for water run-off through the canyon. All oncoming traffic is unseen until the last possible moment, and you better pray your tires hang on to the lousy pavement, usually covered with mud and debris...especially at the stupid speeds used. BUT, the 'Yata, with the new bushings, blasted through without the usual bangs and rattles from the doors that I never noticed, until I could not hear them anymore! Totally anecdotal, but I swear the car held the turns and sweeps better than ever. Best unprofessional chassis stiffening parts you never knew you needed!

Like I said, genius!

The foot well was getting too warm on long trips. Now it’s as cool as a cucumber!

I have a Mazdaspeed Miata with an FM exhaust kit and I installed two of these blankets. A lift made installation very easy, I don’t think I could have done this on jack stands.

A couple of YouTube vids and removal was easy. Installation just as easy. Oh, and it looks great. Right replaced, left original

It fits perfectly, just make sure you tighten it all the way. I was even able to still use the radio with a bit of static here and there.

Solves a potential issue and looks cool

Put it on jack pad, then jack up under the mirror. Now both tires can be swapped, or rotated :). Less work, no damage to pinch weld.

Works and looks great

Great sound. Adds a little bit of grunt.